Wiring and Sensors
What additional hardware will help me test and wire my MegaSquirt
®
?
Is there a wiring schematic for the sensors, injectors, etc.?
What connectors do I use and where can I get them?
What is the relay board?
How do I make a wiring harness pigtail?
What should I know about oxygen sensors?
What temperature sensors can I use with MegaSquirt?
What is EasyTherm?
How do I choose a throttle position sensor?
Can I use other MAP sensors?
How do I convert pressures (kPa, Hg, psi, etc.)?
What is a fast idle air valve?
What size wire should I use?
What are the MegaSquirt
®
physical size and power requirements?
What if I don't get a good ignition signal for MegaSquirt?
Why don't my temperature sensors and TPS work with my Relay Board?
Can I share temperature sensors between MegaSquirt
®
and my existing ECU?
Click on one of the following links for answers to many more frequently asked questions:
How to Purchase
How MegaSquirt
®
Works
/
Code
Assembly & Testing
Wiring & Sensors
Fuel Injectors and Supply
Tuning
Turbocharging & MegaSquirt
®
MegaSquirt
®
Related Hardware
Links
MegaSquirt
®
is an experimental device intended for educational purposes.
MegaSquirt
®
controllers are not for sale or use on
pollution controlled vehicles
. Check the laws that apply in your locality to determine if using a MegaSquirt
®
controller is legal for your application.
©2004, 2007 Bruce Bowling and Al Grippo. All rights reserved. MegaSquirt
®
is a registered trademark.